nanocomposite membrane in membrane bioreactor (MBR) system in order to oil refinery wastewater treatment. For this purpose, three levels of aeration rate with specific aeration demand per membrane area (SADm) of 0.5, 1, and 1.5 m3/m2h was used. According to the obtained results, PP nanocomposite membrane showed high hydrophilicity, porosity, and high flux compared to neat PP membrane. Also, either low or high aeration rate had a negative influence on permeability and antifouling properties of neat PP and nanocomposite membranes. The analysis of fouling mechanism for both membranes based on Hermia’s model revealed that the cake formation is dominant mechanism for lower aeration rate while by increasing aeration rate, all models couldn’t predict experimental data. Meanwhile, by increasing aeration rate, chemical oxygen demand (COD) removal for activated sludge and both membranes decreased and increased, respectively.
